Hello Innovaphone,

I try to make a communication between a OpenText gateway 904 (4 BRI port) and a Innovaphone PBX (IP6010, port ISDN TEL)

I tested several configuration on IP6010
I found several links in the wiki
http://wiki.innovaphone.com/index.php?title=Reference:Configuration/BRI/Protocol
http://wiki.innovaphone.com/index.php?title=Howto:How_to_Configure_EDSS1_Partial_Rerouting

In first, I put the pysical interface (TEL) in NT mode then I made a test with protocol QSIG Ecma1. My interface TEL is passed UP but when I made a test to send a fax, I had an error message "channel is busy" on OpenText Gateway...

Do you have an idea to make a communication between Opentext Gateway 904 and PBX Innovaphone (IP800 or IP6010... ) by ISDN port ???

Thanks in advance.
Best regards,

Jean-François